EMC DEE-1721 Dumps PDF | DEE-1721 Exam Study Material | Realexamdumps.com
                     EMC DEE-1721 Dumps PDF
           E x  p e r t   –   I m  plementation Engineer, SC Series Exam
For More Info:
https://www.realexamdumps.com/emc/dee-1721-practice-test.html
 
Question: 1 
     
Several servers connected to the Storage Center through FC fabrics using WWN zoning. You recently 
replaced a server’s FC HBA; however, the server no longer connects to the Storage Center. 
What is causing this issue? 
 
A. Storage Cento fault domains must be updated with the new HBA WWN 
B. Storage Center fault domains must be converted to Virtual Pat Node 
C. Server's zone must be updated with the new switch port to which the HBA is connected 
D. Server's zone must be updated with the new NBA WWN 
 
Answer: D         
 
Question: 2 
   
A storage administrator has multiple servers connected to the Storage Center through two iSCSI 
networks. You use a software iSCSI Initiator on the servers and the Storage Center runs in Virtual Port 
Mode. 
Which IP address is required in the iSCSI Initiator for proper connectivity? 
 
A. Primary IP address for each domain 
B. Control Port IP address for each domain 
C. Reserve IP address for each domain 
D. Management IP address of each controller 
 
Answer: B     
 
Question: 3 
   
Which processes should be used when testing controller failover on a newly installed Storage 
Center? 
 
A. Start server IO to a volume, restart a controller, then rebalance ports and ensure no IO errors. 
B. Start server IO to a volume, restart either controller, and ensure no IO errors are reported. 
C. Start server IO to volumes owned on each controller, restart the controllers sequentially, and 
ensure no IO error. 
D. Start server IO to volumes owned on each controller, restart the controllers simutaneously. and 
ensure no IO error. 
 
Answer: D     
 
 
Question: 4 
   
Exhibit: 
You are troubleshooting disk connectivity issues on an SC9000. The SC9000 has two SC220 enclosures 
on one chain and two SC280 enclosures on the other chain. You verify the physical cabling and 
discover the array is cabled as shown in the exhibit. 
 
What identities the issue with how the environment is cabled? 
 
A. Chain containing the SC220 storage enclosures is cabled incorrectly 
B. Chain containing the SC220 storage enclosures must be divided into two separate chains 
C. Chain containing the SC220 storage enclosures is cabled incorrectly 
D. Chain containing the SC280 storage enclosures must be divided into two separate chains 
 
Answer: B     
 
Question: 5 
   
After setting up an SC4020 and turning on the system, both controllers initialize to Safe Mode and are 
ready for configuration You plug the serial cable into the first controller and type the platform prejoin 
show command You then receive the command output shown in the exhibit 
 
 
If you continued configuring the controller, what are the reasons why the deployment will fair? 
 
A. Serial cable needs to be plugged into the top controller Controller chassis is installed upside down 
in the rack 
B. Serial cable needs to be plugged into the top controller eth1 IPv4 IP address used at the factory to 
load the firmware was not cleared before shipping 
C. Serial cable needs to be plugged into the bottom controller eth1 IPv4 IP address used at the 
factory to load the firmware was not cleared before shipping 
D. Serial cable needs to be plugged into the bottom controller Controller chassis is installed upside 
down in the rack 
 
Answer: D     
 
Question: 6 
   
You added an existing Storage Center to an instance of Dell Storage Manager using the Volume 
Manger user. You are able to map volumes in the 10K folder to the servers but not the volumes in the 
 
SSD folder. 
What is the reason for this issue? 
 
A. Only the Administrator user can map volumes in the SSD folder. 
B. Volume Manager user can only access one disk folder 
C. Volume Manager user is a member of a group that is restricted from the SSD folder 
D. Servers cannot detect SSD drives 
 
Answer: B